Well balanced alkaline cleaner. It is free hydrocarbon solvents.Gentle & sutable for tank cleaning operation. A very strong alkaline cleaner, which can be used to soften up / remove baked on drying oils and also used after animal and vegetable oils, fish oils, tall oils, tung oil etc. It is low toxic product with an exceptional solvency power on soil & oily matter.It is free from Hydrocarbon solvents , Biodegradable and minimizes the extreme hazards to personnel in handling materials.
It can be used as a general purpose cleaner to remove oil and grease deposits.First of all flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of using RXSOL-20-2015-020 is by direct injection followed by recirculation washing, using tank cleaning machines. Spraying Method - Using LAC as delivered in drums, spray onto areas where residue remains following rough washing leave for 10-45 minutes (but do not allow to dry), then butterworth at maximum pressure and warm water 60oC for at least 3 hours, checking that there is no foam remaining in the final stages. Inspects tanks(s) and if desired result has been achieved fresh water rinse and dry.
** Make sure to take all safety precautions are followed when handling / spraying RXSOL-20-2015-020
Injection Method – not applicable.
Refer to technical datasheet
-
Removes grease, oil, carbon deposits, soil and grime.
-
Keeps loosened deposits in suspension preventing re-deposition.
-
Low toxic. , Non-flammable.
-
Free from hydrocarbon solvents.
-
Effective and economical in use , Water-based cleaner.
-
RXSOL-20-2015-020 has numerous cleaning applications including removal of greases, waxes,
-
oil, sludge, soot, carbon deposits and general dirt and grime.
-
Non-corrosive to ferrous metals. Suitable for all tank-coatings.
-
Can be used for gas and hydrocarbon freeing of tanks.
-
Can be used for deodorizing
- Contains wetting agents.
NOTE : Acts as an acid-neutralizing agent.
Re-circulation Method :
Fill tank with fresh water and heat up to warm 50 oC .IF a drop line is available on the tank line system, then start to circulate the water and add the required amount of Caustic flakes and LAC to make a 2.5% solution. A stronger solution can be made, but be advised that too much Caustic and too high temperature will result in white powder all over the tank. Under normal circumstances, between 2.5% and 4.5% will be sufficient strength. If there is no drop line, then lower butterworth hoses into the tank from the pump stack header without machines attached and circulate through these hoses while you fill the solution material.
* Use a strainer at the pump stack when circulating any solution.*
Tank Lining – Stainless / Epoxy / Phenolic
ALKACLEAN s. LAC supplier and exporter. Cleaner, Alkaline Marine Degreaser, Alkaline Heavy Duty, For Removing Oil, Grease, Fats and Other Soils, Packed in 25 Ltr Pail and also in 50, 210 Ltr
| ProductName | ALKACLEAN s. HD LAC |
| Part Number | RXSOL-20-2015-020 |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Stock Point : Mumbai, Chennai, Kandla, Kolkata, Visakhapatnam, Muscat, Fujairah
| Phone | +91 22 27815540 / 41 / 42 |
| Fax | +91 22 2781 1318 :::AOH :0091 9821214367 |
| mail@rxmarine.com |
Alkaline cleaner Declaration according to recommendation 89/542/EEG.
|
Blend of SURFACTANT ANIONIC NON-IONIC, LAB |
Proprietory Blend |
40-50 |
| Butoxydiglycol | 112-34-5 | 1-5 |
|
Sodium Nitrite |
7632-00-0 |
0.1-1 |
|
C9-11 Pareth-6 |
68439-46-3 | 1-5 |
|
Butoxyethanol |
111-76-2 |
1-5 |
| Sodium Xylenesulfonate | 1300-72-7 | 1-5 |
| Sodium Hydroxide | 1310-73-2 | 1-5 |
| Tetrasodium EDTA | 64-02-8 | 0.1-1 |
| CI 15620 | 1658-56-6 | 0.1 |
| Sodium Metasilicate | 6834-92-0 | 2 - 5 |
Hazard phrases
Harmful if swallowed .
Causes severe skin burns and eye damage ).
Wear protective gloves/protective clothing/eye protection/face protection.
IF SWALLOWED: rinse mouth. Do NOT induce vomiting .
IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing.Rinse skin with water/shower.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing
Immediately call a POISON CENTER or doctor/physician.
| Inhalation |
Remove Patient to fresh air. Seek medical advice if necessary |
| Eye Contact |
If substance has got into eyes, immediately wash out with plenty of water for at least 15 minutes Irrigate eyes thoroughly whilst lifting eyelids Obtain immediate medical attention Continue flushing with water until medical help arrives |
|
Ingestion |
Do not induce vomiting.Never give anything by mouth to an unconscious person Give water or milk to drink Obtain immediate medical attention |
| Extinguishing media | Not flammable. In case of fire use extinguishing media appropriate to surrounding conditions |
| Special hazards arising from the substance or mixture |
Smoke from fires is irritating |
| Advice for firefighters | Wear Breathing Apparatus |
| Personal precautions, protective equipment and emergency procedures | Wear protective clothing as per section |
| Environmental Precautions | Do not allow to enter public sewers and watercourses |
| Methods and material for containment and cleaning up | Absorb spillage in inert material and shovel up.Ventilate the area and wash spill site after material pickup is complete |
| Reference to other sections | Section 13 |
| Precautions for safe handling |
Eyewash bottles should be available. Do not get in eyes, on skin, or on clothing |
| Conditions for safe storage, including any incompatibilities | Store materials in cool and dry place. The container should be tightly closed.Store in a well-ventilated place |
| Protect from | Direct Sunlight |
Control Parameters - Potassium Hydroxide
Exposure controls - No special ventilation is required unless the product is used in a spray form
Occupational exposure controls
|
Body Protection |
Wear suitable protective clothing, including eye/face protection and gloves. |
|
Eye Protection |
Wear eye protection (on possibility of contact ) |
|
Hand protection |
Wear PVC chemical resistance protective glove |
Gloves Goggles
|
Appearance |
Clear liquid |
|
Density |
In g/cm3 at 20°C: 1.05-1.1 |
|
Boiling Point |
98°C - 100°C |
|
Flash Point |
Not Applicable |
| pH |
Alkaline ( 13 ) |
|
Compatibility |
|
|
Metal |
No Known Effect |
|
Rubber |
No Known Effect |
|
Solubility |
100% soluble in water |
| Reactivity | No hazardous reactions known if used for its intended purpose |
| stability | Considered stable under normal conditions |
|
Hazardous reactions |
No hazardous reactions known if used for its intended purpose |
| Conditions to avoid | Not Determine |
| Incompatible materials | Incompatible with acid and oxidizing substances |
| Hazardous Decomposition Products | No hazardous decomposition products known |
| Information on toxicological effects | LD50 (oral,rat) >10,000 g/kg |
| Contact with eyes | Can cause damage to the eyes |
| Contact with skin | Causes redness and irritation.Prolonged skin or eye contact may cause chemical burns. |
| Ingestion | The ingestion of significant quantities may cause burning sensation.The ingestion of significant quantities may cause damage to digestive system |
| Inhalation | In cases of severe exposure, irritation may develop |
Product has not been tested for environmental effect.
As per guideline of local rules and regulation and before disposal and neutralization pl. refer 07 article.
Do not discharge into drains or the environment, dispose to an authorised waste collection point
| Proper Shipping Name |
Sodium hydroxide, solution |
|||
| UNNo. | 3266 | |||
| Hazard Class | 8 | PackingGroup | II | |
| Road/Rail(ADR/RID) | ||||
| Proper Shipping Name |
Sodium hydroxide, solution |
|||
| ADR UN No. | 3266 | |||
| ADR Hazard Class | 8 | Tremcard |
80S1824 |
|
|
Sea(IMDG) |
||||
| Proper Shipping Name |
Sodium hydroxide, solution |
|||
| IMDG UN No. | 3266 | |||
| IMDG Hazard Class. | 8 | IMDG Pack Group. | II | |
| IMDG EmS | F-A, S-A | IMDG subrisk |
N/A |
|
| IMDG Labels |
8 |
IMDG Flash point |
N/A |
|
|
Air(ICAO/IATA) |
||||
| Proper Shipping Name |
Sodium hydroxide, solution |
|||
| ICAO Un No. | 3266 | |||
| ICAO Hazard Class | 8 | ICAO Packing Group. | II | |
| ICAO subrisk |
N/A |
ICAO Labels |
8, CAO |
|
| ICAO Flashpoint | N/A | |||
|
DOT/ CFR (US Department of Transportation) |
||||
| DOT Proper Shipping Name |
Sodium hydroxide, solution |
|||
| Hazardous Material |
Sodium hydroxide |
|||
| Hazard Class | 8 | Identification Number | UN 3266 | |
| DOT subrisk | N/A | |||
| DOT Labels | 8 | DOTFlashpoint |
N/A |
|
Classification and labelling according to Chemicals Hazard Information and Packaging Regulations (CHIP). Symbols of danger :- C Corrosive
|
R phrases |
R 35 : Causes severe burns |
|
S-phrases |
S2: Keep out of reach of children S26 :In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S28 : After contact with skin, wash immediately with plenty of water. S37/39 : Wear suitable gloves and eye/face protection. |
The information above is believed to be accurate and represents the best information currently available to us. However, we make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and we assume no liability resulting from its use. Users should make their own investigations to determine the suitability of the information for their particular purposes. In no event shall RX Marine International be liable for any claims, losses, or damages of any third party or for lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if RX Marine International has been advised of the possibility of such damages.
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.