ALKALINE EXTRA Non-caustic cleaning and degreasing SHIP HOLD Cleaning agent, Alkaleen Liquid Heavy Duty is water based powerful ship hold Cleaner. RXSOL-22-2005-220 is a superior Heavy duty and highly concentrated Alkaline Cleaner, containing specially selected detergents and powerful long chain organic syndet , specific salts with surfactants & wetting agents . It is low toxic product with an exceptional solvency power on soil & oily matter & having good foaming qualities. It is free from Hydrocarbon solvents, Biodegradable and minimizes the extreme hazards to personnel in handling materials. It is suitable for SHIP HOLD CLEANING used for cargo hold cleaning after coal and pet coke..
ALKALINE EXTRA SHIP HOLD CLEANER FOR CLEANING OF COAL AND VEGETAL OIL TANKS AND BOILERS FIRE SIDE. This product developed and specialized for SHIP HOLD CLEANING and most commonly used for cargo hold cleaning after coal and pet coke.
It can be used as a general purpose cleaner to remove oil and grease deposits.
Using Procedure:
- Recommended concentration for general cleaning: 5-10%
- Recommended concentration for manual cleaning/spraying: 10 - 20 %
Spraying method:
First of all clean and broom the entire area or you can clean with cold water to prevent extra chemical requirement. Then by using spraying machines spray the diluted alkaline extra on entire surface. Directly spray on the contaminated area and let it act for 5-10 minutes. Then clean the system under high pressure. A solution of 5-10% in fresh water can be used for this purpose also , and may be sprayed on and hosed off using high pressure.
PET COKE CLEANING :-
Deposition and Contamination of coal plays important role during cleaning, For Heavy deposition RXSOL-22-2005-220 can be used concentrated ( without dilution ) Spray the product on entire surface area and let it absorve for 15-20 minutes, then Wash with fresh or sea water. Otherwise it can be diluted up to 5 -10% depends on the deposits and contamination .
Product Properties:
|
Appearance |
Pale Yellow brownish liquid |
|
Density |
In g/cm3 at 20°C: Spec. gravity : 1.035 |
|
Compatibility |
|
|
Metal |
No known effect |
|
Rubber |
No known effect |
|
pH |
Alkaline ( 12.7 - 13 ) |
|
Flash point |
Not Applicable |
|
Solubility |
100% soluble in water |
FAQs — Alkaleen Extra Heavy Duty1) What is Alkaleen Extra Heavy Duty used for?A non-caustic, heavy-duty alkaline cleaner for ship hold cleaning, especially after coal and pet coke. Also suitable for degreasing heavy soil and oily deposits on marine and industrial surfaces. 2) Is it safe for the crew to handle?Yes. It is low-toxicity, free from hydrocarbon solvents, and biodegradable. Still use gloves, goggles, and ensure ventilation. 3) Can it be used on all surfaces?Safe on most painted, coated, and metallic surfaces when used at recommended dilution. Spot-test on sensitive coatings first. 4) How is it applied?Apply via high-pressure machines, brush, or spray; suitable for soaking/immersion. For cargo holds, foam cleaning improves contact time. 5) Is it environmentally friendly?Yes. The formulation is biodegradable; dispose of rinsate per local regulations. 6) What makes it different?Non-caustic yet highly effective solvency on soil and oil. Uses long-chain organic syndets, surfactants, and wetting agents for deep penetration and fast cleaning. 7) Other applications beyond marine?Yes. Effective for industrial degreasing, equipment cleaning, and other heavy-duty maintenance where strong, safe alkaline cleaning is needed. |
Wear safety Gloves and Eye protective Goggle.
| Product Name | RXSOL-22-2005-0220 |
| Product Type | Alkaleen EXTRA Liquid Heavy Duty |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Stock Point ::: Canada, Muscat, Fujairah, Kenya Mombasa, Mumbai, Gandhidham, Kolkata, Vizag, Chennai
| Phone | +91 22 27815540 / 41 / 42 |
| Fax | +91 22 2781 1318 AOH :0091 9821214367 |
| mail@rxmarine.com | |
| Website | www.rxmarine.com |
SURFACTANT ( ANIONIC & NON-IONIC ) , LAB, Alkaline Sodium hydroxide Strong alkaline cleaner Declaration according recommendation 89/542/EEG.
chelating agents, meta silicate and additives (biodegradable > 90%)
Water, Silicate, Isotridecanolethoxylate, Organic compound.
HAZARDOUS INGREDIENTS:
CAS NO. EINECS NO. CHEMICAL NAME WT % SYMBOL R-PHRASES
1310-58-3 2151855 Potassium hydroxide 15 - 20 C 35
6834-92-0 2299129 Disodium metasilicate 1 - 5 C 34,37
9043-30-5 Polymer Isotridecanolethoxylate 1 - 5 Xn 22, 41
Refer to section 16 for descriptions of relevant risk phrases and Notas.
*See Section 16
|
Environmental Hazards |
None |
|
Human Health Hazards |
R 35:Causes skin burning effects |
|
Inhalatin |
NO Fumes, Harmful supply or remove to fresh air and seek medical advice attention. |
|
Skin Contact |
Rinse with running water and soap. Skin care. Remove contaminated clothes. |
|
Eye Contact |
Flush with running water for at least 15 minutes Immediately . |
|
Ingestion |
Vomiting is dangerous , seek medical attention. |
Non Combustible Porduct
|
Suitable |
N.A. can use foam dry Co2 , water-spray. |
|
Not suitable |
Not applicable |
|
Special |
Not applicable |
|
Protection of fire Fighter |
Not applicable |
Special protective equipment for fire-fighters: Wear protective equipment.
|
Enviromentel Precaution |
Direct flow into drainage system, surface or ground water is prohibited. |
|
Cleaning Method |
Flush Spill Area with Water and remove with liquid-absorbing material like foam sand,sawdust etc.. |
|
Condition to Avoid |
Non flammable but avoid direct heating |
|
Materials to Avoid |
Do not subject to Acidic / Oxidizing Agents |
|
Handling |
Keep Container Tightly Closed |
Note:Eyewash facilities require at workplace The product causes corrosion on skin and mucous membranes Pl. Note that In case of discharge
of acidic or alkaline products into the sewerage system the pH must be in the range of 6-10 since higher or lower pH values may damage the
sewerage system or impair biological dosage treatment plants. So that for maintaining pH we have to add acidic / basic medium neutaliser .
For example if pH is less than 6 basic neutraliser is required and if pH is more than 10 acidic nature neutraliser is required. •Dilute in water (always use plastic jar )
Personal protection :
|
Respiratory System Protection |
Approved respirator must be worn when spraying |
|
Eye Protection |
Cear eye protection (on possibility of contact ) |
|
Hand protection |
Cear PVC chemical resistance protective glove |
Gloves Suit Goggles No_Smoking
Product Properties:
|
Appearance |
Pale clear liquid |
|
Density |
In g/cm3 at 20°C: Spec. gravity : 1.035 |
|
Compatibility |
|
|
Metal |
No known effect |
|
Rubber |
No known effect |
|
pH |
Alkaline ( 12.7 - 13 ) |
|
Flash point |
Not Applicable |
|
Solubility |
100% soluble in water |
|
Packaging |
Size (in Litres) |
|
Hazardous Decomposition Products |
Do not occur if stored and used as directed. FIRE combustion CO, CO2 , NH3 , SOX etc hazardous gas produced |
NOTE : Avoid Contact With Acid
Comment - Not applicable , Emulsifies in water and biodegradable.
95 % added surfactants are biodegradable as per by international regulation .This material must be disposed with local national regulations.
As per guide line of local rules and regulation and before disposal and neutralization pl. refer 07 article.
|
Proper Shipping Name |
||||
|
UN |
||||
|
Proper Shipping Name |
Alkaline hydroxide, solution |
|||
|
UNNo. |
1824 |
|||
|
Hazard Class |
8 |
PackingGroup |
II |
|
|
Road/Rail(ADR/RID) |
||||
|
Proper Shipping Name |
Alkaline hydroxide, solution |
|||
|
ADR UN No. |
1824 |
|||
|
ADR Hazard Class |
8 |
Tremcard |
80S1824 |
|
|
Sea(IMDG) |
||||
|
Proper Shipping Name |
Alkaline hydroxide, solution |
|||
|
IMDG UN No. |
1824 |
|||
|
IMDG Hazard Class. |
8 |
IMDG Pack Group. |
II |
|
|
IMDG EmS |
F-A, S-A |
IMDG subrisk |
N/A |
|
|
IMDG Labels |
8 |
IMDG Flash point |
N/A |
|
|
Air(ICAO/IATA) |
||||
|
Proper Shipping Name |
Alkaline hydroxide, solution |
|||
|
ICAO Un No. |
1824 |
|||
|
ICAO Hazard Class |
8 |
ICAO Packing Group. |
II |
|
|
ICAO subrisk |
N/A |
ICAO Labels |
8, CAO |
|
|
ICAO Flashpoint |
N/A |
|||
|
DOT/ CFR (US Department of Transportation) |
||||
|
DOT Proper Shipping Name |
Alkaline hydroxide, solution |
|||
|
Hazardous Material |
Alkaline hydroxide |
|||
|
Hazard Class |
8 |
Identification Number |
UN 1824 |
|
|
Product RQ (lbs) |
3640 |
DOT subrisk |
N/A |
|
|
DOT Labels |
8 |
DOTFlashpoint |
N/A |
|
Classification and labelling according to Chemicals Hazard Information and Packaging Regulations (CHIP). Symbols of danger :- C Corrosive
|
R phrases |
R 35 : Causes severe burns |
|
S-phrases |
S2: Keep out of reach of children S26 :In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S28 : After contact with skin, wash immediately with plenty of water. S37/39 : Wear suitable gloves and eye/face protection. |
This information is based on our current level of knowledge and relates to the product in the state in which it is delivered. It is intended to describe our product from the point of view of safety requirements and is not intended to guarantee any particular properties
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.